Universal, Non-Hazardous & Hazardous Waste Disposal Services

Use the links on the left to find out more information for the appropriate waste disposal.

Lead Paint and PCB Caulk Management

LEAD PAINT PREPARATION

EET offers full service with an unequivocal expertise in this area. Please call or email for an assistance program to be put in place for your site now.

LEAD PAINTED WOOD OFF SITE PREPARATION

Off site waste preparation is a very sensible avenue for generators and/or contractors concerned with generator liability and keeping costs down. Ultimately what it offers is “secure” storage containers, and all preparation done off site, further reducing liability. It is also especially effective in areas where space is limited and noise pollution is a factor. As in the case of on site preparation, it is designed to reduce extensive contractor labor.

  • Lead painted wood is abated and stored in secured, hazardous labeled roll off container(s) or van trailer(s) by contractor.
  • Metal hinges, door handles, window glass, window locks and any metal less than three inches may be left on the debris. However, NO ALUMINUM is acceptable.
  • Material may be loosely stacked or wrapped in small amounts of polyethylene within the container.
  • Waste is transported to interim facility, for size reduction. Wood is fed into custom chipping units utilizing full secondary containment, air exchange, and HEPA filtering.
  • Waste is transported to TSDF for recycling process described above.

LEAD PAINTED METAL OFF SITE PREPARATION

  • Lead painted metal is abated and stored in hazardous permitted roll off container(s) or van trailer(s) by contractor.
  • Material may be loosely stacked or wrapped in small amounts of polyethylene.
  • Waste is transported to interim facility, where it is prepared for ultimate disposal.
  • Metal components are prepared by a series or air pressures, removing the contaminant.
  • Any resulting hazardous waste (lead paint chips, dust, etc.) is accumulated in drums and shipped to a fully permitted TSDF for final disposal.
  • Paint free metal components are disposed of as construction and demolition debris (C & D).

ON SITE SAFETY & TRAINING

    • All site personnel are trained in accordance with 29FR1910.1025.
    • All site personnel undergo medical monitoring to ensure compliance with applicable regulation.
    • Negative air systems with dust collectors and HEPA filters are utilized to eliminate the possibility of contaminated air discharge.
    • Ambient air monitoring is performed both inside and outside of the mobile unit while operating.
    • Personal air sampling pumps are worn by personnel in the work room.
    • Personnel are further protected by protective equipment, including disposal coveralls (IE: Tyveks), eye protection, hard helmets, gloves, boots and air purifying respirators

with HEPA cartridges.

Service Inquiry

Company Name*

Full Name*

Your Email*

Phone*

Choose Recycling & Disposal needs*:

Subject

Your Message